服务热线:400-6688-603

来源:  日期:1970-01-01

  道旗一般采宝丽布喷绘,户外写真布喷绘,热转印旗帜布等 。可以做单喷单看、单喷双看和双喷双看等效果,还有全弹涤纶或牛津布面料,运用高温分散染料透印工艺:布正反面颜色一样,无色差,图形与旗面柔软度一样,水洗日晒不掉色。但色彩效果不如喷绘布,并且喷绘布的防水性也要比涤纶布针织布好。

  Flag used for polaroid printing cloth, outdoor pictorial cloth printing, heat transfer printing cloth banner. Can do a single single, single jet spray and double double double see effect, and the elastic polyester or Oxford cloth fabric, using high temperature disperse dyes through printing cloth: positive and negative color, no color, graphics and flag softness, washing the sun does not fade. But the color effect is better than the spray cloth, and the waterproof property of the spray cloth is better than that of the polyester cloth.

  道旗的尺寸一般有:60×190、80×240 、120×350等常用规格,山东喷绘膜广告也可以根据要求尺寸的制作道旗。路边道旗。设置路边道旗的总高度不超过2米。三角形道旗,其立边长度(高度)不超过0.5米,底边长度(宽度)不超过0.5米;方形道旗,其立边长度(高度)不超过0.7米,底边长度(宽度)不超过0.5米。

  Road flag size generally: 60 * 190, 80 x 240, 120 x 350 commonly used specifications, but also according to the requirements of the size of the road flag. Roadside flag. The total height of the roadside Flag shall be no more than 2 meters. Triangular flag, the vertical edge length (height) of less than 0.5 meters, the length (width) of not more than 0.5 square meters; flag, the vertical edge length (height) of less than 0.7 meters, the length (width) of less than 0.5 meters.

  应将基层上附有的各种杂物,如:灰尘、油脂、锈迹及酥松、起砂、起粉部位等,采用高压水冲洗、机械打磨等方法彻底清除干净。

  These should be attached to the base of debris, such as dust, grease, rust and loose sand, powder, such as position, using high pressure water washing, mechanical polishing method completely clean.

  对墙面装饰塑料凹线条,如需描漆,凹槽必须清理干净;反之,先于凹槽作涂抹薄油层处理,涂装结束后,将油层抹除,充分还原凹槽本色。
喷绘膜广告生产厂家

  For the wall decoration plastic concave line, if you need to paint, the groove must be cleaned; on the contrary, prior to the groove to smear the thin oil reservoir treatment, after the end of the coating, the oil layer will be erased, and the groove quality will be fully restored.

  基层的破损、洞穴、裂缝、空鼓起壳等状况要事先修补,用腻子抹平,打磨光滑,阴阳角线条要垂直,基层的平整度要控制在允许的范围内。

  Base damage, caves, cracks, hollowing of the shell prior to repair, putty smooth, polished, yin and yang angle to vertical lines, the smoothness of the base should be controlled in allowable range.

  新抹灰的墙面要养护2周后,方可进行腻子批嵌和涂料施工。

  The new plastering wall should be maintained for 2 weeks before it can be used for putty, batch embedding and coating construction.

  涂料施工时基层含水率应小于10%,同时应确保各修补处与主体墙体含水率一致,方可进行施工。

  Coating construction, the base moisture content should be less than 10%, at the same time should ensure that the repair and the main wall moisture content consistent, before construction.

  外墙墙面若有酥松、起砂、起粉的情况,应将其彻底清除,再用乳液型砂浆进行补平。

  If the external wall Susong, sand, powder, should be thoroughly cleaned, and then emulsion mortar filling.

  本文的精彩内容来自山东喷绘膜广告详细内容请点击我们的官方网站:/谢谢您的到来!

  The wonderful content of this article comes from Shandong inkjet film advertising details, please click on our official website: / thank you for coming!

上一篇:墙体艺术的潜在信息输出能力
下一篇:山东喷绘膜广告的聚合效应和长尾优势
XML 地图 | Sitemap 地图